Q.
What’s the best way to do a surface model of something like a car-then split it up into panels?
Mike Harper, Lennox International (Allied Air Enterprises)
Continue reading Surface Models of Car Body Panels
(333)
Q.
What’s the best way to do a surface model of something like a car-then split it up into panels?
Mike Harper, Lennox International (Allied Air Enterprises)
Continue reading Surface Models of Car Body Panels
(333)
There are situations when a set of models needs to be renamed with a common base part number and incremental dash numbers. The technique documented below will speed up the renaming of these files especially if there are a large number of files to be renamed.
Continue reading Renaming Creo Files with Suffixes
(6667)
Q.
This part was saved with the flat pattern suppressed, the size is: 4,776 KB. The exact same part saved with the flat pattern resumed, the size is: 1,717 KB. How is this possible?
David P Engvall, Newell Rubbermaid Inc.
Continue reading Creo Parametric File Size
(1079)
Q.
How can I prevent a model from bringing back the skeleton surface color on regeneration?
David P Engvall, Newell Rubbermaid Inc.
Continue reading Copy Geom Skeleton Surface Color
(875)
Q.
How do you create a radial pattern of holes or features in a part such that when you detail the features in a drawing you will get a radial axis pattern on the drawing?
Mark Dristy, PE – Marc Edward LLC
Continue reading Radial Pattern Axis Circle
(2372)
Q.
I don’t need to create molds or tooling but I sometimes need to verify that a plastic part I’ve designed can be created. Is there a tool or analysis that can point out potential issues with my injection molded part? For example, draft angle is the wrong direction or there are undercuts.
April Ruggles, Lenovo
Continue reading Plastic Part Analysis
(590)
The article below was originally posted by David A. Haigh of Lawrence Livermore National Lab on the PTC/User Forum site. The article provides helpful instructions on how to set-up email streams on the new PTC Communities. A special thanks to David for allowing us to repost on the Pro/Users of the Carolinas site. Continue reading PTC Community – Setting Up Email Streams
(520)
Email from Dan Glenn regarding migration of PTC/User portals into the PTC Community…
Continue reading PTC/User Portal Migration Into PTC Community
(1057)
(293)
Dave Engvall presented the following information at the 2014 Fall event. Continue reading Easy Animation That YOU Can Use
(192)